Weight Loss

Easy Ways to Remove Kitchen Sink Drain

Remove Kitchen Sink Drain

There are many ways to remove a kitchen sink drain, but how do you know which one is the best for you? If there is no trap below the sink, then it’s usually easiest to disconnect the tailpiece and lift it out from under the counter.

However, if there is a trap below the sink, then you may need an adjustable wrench or channel locks to loosen and unscrew your pipes before removing them. After that, all you have left to do is clean up!

This blog post talks about how easy it can be to remove kitchen sink drains.

Here are 6 Steps to Remove Kitchen Sink Drain

Step 1: Stop Water Supply

It’s not always necessary to turn off the hot and cold water supply at your sink. But it is better for a novice plumber in training.

Turning on the faucet without turning off these valves can cause some messy things. Such as flooded cabinets or even flooding floors if you have installed touchless kitchen sinks.

Step 2: Loosen the Drainpipes

The connector ring that joins the P-trap and tailpiece from your sink drain is a tough nut to crack. If you want to get it off as quickly as possible, use an adjustable wrench.

With a clockwise or counterclockwise motion depending on whether you’re loosening or tightening. Once undone, take care not to lose any of its parts by disengaging them manually in order. So they don’t fall into the gaping abyss below!

Step 3: Unfasten Lock Nut

A lock nut, also known as a basket nut or sink strainer bolt, is used to secure kitchen sinks. When this tightens enough and the sealing components like plumber’s putty and rubber washers are in good shape then your drain should not leak at all.

If you notice that it does leak though there may be one of two problems with either the sealant ingredients being compromised. Because someone didn’t tighten up the nuts quite right on their own plumbing project under there!

When a locking nut is tight enough, and the sealing components are in good shape, your sink drain should not leak. If it does though, any of those could be to blame!

A little tightening on that locknut might do you some good if your kitchen sink has been leaking lately.

Step 4: Remove Basket Strainer

After you have disengaged the lock nut, removed the friction protection and rubber washer sealing off the bottom of the sink’s drain hole. This is followed by removing the basket strainer from under it all.

Make sure to use a reasonable force when doing this or else risk pushing the whole basin off the countertop!

Step 5: Install the New Drain Strainer

To install a new sink drain strainer, turn the basket upside down and apply some plumber’s putty around its body. Put the draining away from you before pressing it onto your kitchen counter.

In order to achieve an even seal with the putty between it and this surface. Don’t press too hard that all of your plumbing adhesives are squeezed out. Clean off any excess as soon as possible after installation so there’s no mess on either side!

Step 6: Link the Drain Strainer

The drain strainer attaches to the sink’s drainage hole and is held in place by a brass tailpiece. Secure it with an O-ring connector, then tighten up your plumbing connections.

To avoid cracking them or bending over time from typical usage of water pressure against these pipes.

Contact Us

Related Articles

Leave a Reply

Your email address will not be published.

Back to top button